Advertisement
To avoid damage to the controller, provide protection against static
electricity.
Do not use solderless terminals to connect cables to the terminal
block.
Solderless terminals may come in contact with the circuit board and
cause malfunctions or damage the controller cover.
To avoid damage to the controller, do not make holes on the
controller cover.
Do not install in the highly humid place such as inside the shower
room etc. The relative humidity range shall be 30% to 90% without
condensation.
2. Component names and supplied parts
The following parts are included in the box.
Parts name
Remote controller (front cover)
Remote controller (top case)
Remote controller (bottom case)
Roundhead cross slot screws M4×30
Wood screw 4.1×16
(for direct wall installation)
Simple manual
*4 The front cover (*1) is already installed on the top case (*2) at factory
shipment.
*5 Remote controller cable is not included.
Do not install the controller on the control panel door.
Vibrations or shocks to the controller may damage the controller or
cause the controller to fall.
Hold the cables in place with clamps to prevent undue force from
being applied to the terminal block and causing cable breakage.
To prevent cable breakage and malfunctions, do not hang the top
controller casing hang by the cable.
Qty.
Appearance
1
Right figure *1
1
Right figure *2
1
Right figure *3
2
2
1
Front cover *1
Eng-3
*4
Bottom case *3
Top case *2
Advertisement
