Table of Contents
Advertisement
SmartBase MPC200/imageCLASS MPC200
Chapter 3: Assembly and Disassembly
Disassembly 12. Carriage unit
(1) Perform disassembly 10, and detach the sensor board.
(2) Remove the left and right shaft clips.
(3) Remove the carriage shaft.
(4) Push the pulley to detach the carriage belt.
(5) Detach the carriage encoder film from the tension spring.
(6) Free the claw (a), and detach the spur unit.
(7) Remove the cable guide, and detach the carriage unit.
Carriage shaft
spur unit
Shaft clip
Tension spring
Pulley
a
Shaft clip
Cable guide
Carriage encoder film
Carriage unit
Figure 3-11 Disassembly 12
3-16
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com
Advertisement
Table of Contents
