Kenwood DDX7017BT Instruction Manual page 59

SETTINGS SETTINGS
❏ <Audio> setting screen
<Equalizer>
Change the sound mode or adjust and store the
equalization for each source. (Page 50)
• Equalizer: Selects the preset sound mode.
– Natural (Initial)/Rock/Pops/Easy/Top40/Jazz/
Powerful/User
• Q factor: Adjusts the width of the frequency.
– 1.35/1.5 (Initial)/2.0
• Bass EXT: Activates/deactivates bass.
– ON/OFF (Initial)
• SW LEVEL: Adjusts the subwoofer level.
– –50 to +10 (Initial: 0)
<Sound Effect>
Adjust the sound effect.
• Loudness: Adjusts loudness.
– OFF (Initial)/Low/High
• Bass Boost: Selects the bass boost level.
– OFF (Initial)/Level 1/Level 2/Level 3/Level 4/
Level 5
• Drive Equalizer: You can reduce the driving noise
by raising the bandwidth.
– OFF (Initial)/ON
• Space Enhancer* 1 : Virtually enhances the sound
space using the Digital Signal Processor (DSP)
system. Select the enhance level.
– OFF (Initial)/Small/Medium/Large
2
• Supreme* : Restores the sound lost due to audio
compression to a realistic sound.
– OFF/ON (Initial)
• Realizer: Virtually makes the sound more realistic
using the Digital Signal Processor (DSP) system.
Select the sound level.
– OFF (Initial)/Level 1/Level 2/Level 3
• Stage EQ: You can move the center of the sound
to the lower or higher point. Select the height.
– OFF (Initial)/Low/Middle/High
<Fader/Balance>
Fader: Adjusts the front and rear speaker output
balance.
• F15 to R15 (Initial: 0)
– When using a two-speaker system, set the fader
to the center (0).
Balance: Adjusts the left and right speaker output
balance.
• L15 to R15 (Initial: 0)
Press [J]/[K]/[H]/[I] or drag [
• To clear the adjustment, press [Center].
<Speaker/X'over>
Select the car type/speaker size and adjust the
crossover frequency. (Page 51)
<Time Alignment>
Select the listening position, then adjust the delay
time of the speaker output to create a more suitable
environment for your vehicle. (Page 52)
<Volume Offset>
Adjust and store the auto-adjustment volume level
for each source. (For discs, the adjustment is stored
for each of the following categories: DVD/VCD, CD,
and DivX/MPEG1/MPEG2/MP3/WMA/WAV/AAC/
FLAC.) The volume level will automatically increase
or decrease when you change the source.
• –15 to +6 (Initial: 00)
1
* You cannot change the setting when "Radio" is selected as the
source.
2
* This function works only when "DISC"/"USB"/"iPod"/
"Android™" is selected as the source.
] to adjust.
ENGLISH 59