en Basic operation
7.15 Switching off the boost function
Press
.
▶
a The boost function is ended before the preset time
expires.
7.16 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched off.
Press and hold
and
1.
To set circulating-air mode (non-regenerable fil-
‒
ter), press
/
until LED 2 lights up in the LED
display.
To set circulating-air mode (non-regenerable fil-
‒
ter), press
/
until LED 3 lights up in the LED
display.
To convert the electronic control back to opera-
‒
tion without the air recirculation filter, press
until LED 1 lights up on the LED display.
To save the setting, press and hold and for ap-
2.
prox. three seconds.
Or wait approx. 10 seconds until the setting is
saved automatically.
To cancel the setting, press .
a A signal tone sounds as soon as the selected set-
ting is saved.
7.17 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off, LED 1
flashes in the LED display for the grease filter satura-
tion display and/or LED 2 flashes for the saturation
indicator for the odour filter.
¡ A repeated signal tone sounds.
Press
.
▶
a The saturation indicator is reset.
7.18 Switching on the lighting
The lighting can be switched on or off independently of
the ventilation.
Press
.
▶
Note: Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.
7.19 Switching off the lighting
Switch off the lighting with
▶
8
for approx. three seconds.
.
7.20 Setting the brightness
Press and hold down .
▶
Note: Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.
7.21 Switching on the button tone
The button tones can be switched on.
Requirement: The appliance is switched off.
Press and hold
1.
a In the LED display, the LED for the setting that is
currently selected lights up.
Press
or until LED 1 lights up in the LED dis-
2.
play.
To cancel the setting, press .
To save the setting, press and hold
3.
prox. three seconds.
/
Or wait approx. 10 seconds until the setting is
saved automatically.
a A signal tone sounds as soon as the selected set-
ting is saved.
7.22 Switching the button tone off
The button tones can be switched off.
Note: Signal tones for the appliance are always
switched on and cannot be switched off.
Requirement: The appliance is switched off.
Press and hold
1.
a In the LED display, the LED for the setting that is
currently selected lights up.
Press
or until LED 2 lights up in the LED dis-
2.
play.
To cancel the setting, press .
To save the setting, press and hold
3.
prox. three seconds.
Or wait approx. 10 seconds until the setting is
saved automatically.
a A signal tone sounds as soon as the selected set-
ting is saved.
7.23 Resetting the appliance to the factory
settings
Requirement: If you reinstall the appliance after disas-
sembly, you will need to reset the appliance to the fact-
ory settings so that the reference movement is carried
out correctly.
Press and hold
▶
a The reference movement is started and determines
the correct actual position of the appliance with a
reference switch.
and
for approx. three seconds.
and
and
for approx. three seconds.
and
and
and
.
for ap-
for ap-