Table of Contents
Advertisement
en Installation instructions
Carefully loosen the screws on the frame cover.
7.
Do not use any tools.
Note: In order to prevent damage to the limit switch,
ensure that lock nuts do not fall into the opening in
the appliance.
Place the frame cover down carefully.
8.
Open the cable cover at the side using a screw-
9.
driver.
Remove the cable on the appliance from the ter-
10.
minal plug and the strain relief.
11.
ATTENTION!
There is a risk of damage to the appliance if the
cable is coiled up.
Always secure the cable firmly using the strain
▶
relief so that it does not coil up fully in the appli-
ance.
Secure the cable on the appliance using the strain
relief so that it does not coil up.
22
Remove the on-site cable from the terminal plug
12.
and remove the protective tube.
Loosen the four cable clamps.
13.
14.
Open the cable tensioner and pull out the cables.
Thread the cables out of the frame cover.
15.
16.
ATTENTION!
There is a risk of damage to the appliance if the
cable is coiled up.
Always secure the cable firmly using the strain
▶
relief so that it does not coil up fully in the appli-
ance.
Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
to secure it.
Remove the diagonally opposite screws on the
17.
frame.
Loosen the two other diagonally opposite screws.
18.
Move the frame and remove it.
19.
Note: If you reinstall the appliance, you will need to re-
set the appliance to the factory settings → Page 8.
Advertisement
Table of Contents
