Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NatComm DP2
Summary of Contents for NatComm DP2
- Page 1 DOOR PHONE For Technical Assistance Please Phone (07) 5596 5128...
-
Page 2: Table Of Contents
TABLE OF CONTENTS DP2 is available in VERTICAL or HORIZONTAL Orientation Description Page Door Phone Dimensions Page Door Phone Range Page Door Phone Performance Page Operation Summary Page Mounting the Door Phone Page Wiring Diagrams Pages Wiring Directions Pages 10-11... -
Page 3: Description
BELL of the Touch Sensitive trigger area orientated in a Horizontal or Vertical Orientation. Our DP2 Door Phones can operate at distances of up to 300 meters from the Controller, providing high quality cabling such as CAT5 is used, or 500m with the DS-SIP Controller. -
Page 4: Door Phone Dimensions
MODEL DP2 DOOR PHONE Page 4 Natcomm... -
Page 5: Door Phone Range
DOOR PHONE RANGE A choice of Three Door Phones are provided for use with our range of Door Station Controller units : Model DP2 - FLUSH MOUNT Compact Size Marine Grade Stainless Steel face plate. Touch Switch operation. Night illumination. -
Page 6: Door Phone Performance
CONTROLLER where ADSL is used on the same line. If you do not do so, volume in both directions will be affected. Refer to your Door Station Controller User Guide for detailed information on the use of ADSL with this product. Page 6 Natcomm... -
Page 7: Operation Summary
After your Door Phone call is completed, there will be a delay of approximately 5 seconds before the unit has reset and is ready for the next call. WHEN TESTING YOUR DOOR PHONE DO NOT USE A TELEPHONE IN CLOSE PROXIMITY AS FEEDBACK WILL CAUSE LOSS OF VOLUME. Natcomm Page 7... -
Page 8: Mounting The Door Phone
85mm, 190mm, D 40mm. SURFACE MOUNTING KITS Stainless Steel Surface Mounting Kits are available for our Model DP2 (Vertical) and DP5 Vertical Door Phones, so that your Door Phone can be mounted ONTO a wall surface, rather than into it. -
Page 9: Wiring Diagrams Pages
Brown - Lock 1 Orange - Lock 1 Black - Power Yellow - Power Red - Audio Green - Audio CAT5 or Similar Connection Cable The colours used are those of the wires in the supplied Interface box. Natcomm Page 9... -
Page 10: Wiring Directions Pages
DOOR PHONE WIRING BLACK POWER POWER YELLOW AUDIO AUDIO GREEN CAT5 CABLE or SOLID CORE CABLE The colours used are those of the wires in the supplied Interface box. Page 10 Natcomm... - Page 11 Note : The polarity of the Audio signal and power connections is not important and can be reversed. Important Note : The colours referred to on this page and page 12 are those of the wires in the supplied interface box. Natcomm Page 11...
- Page 12 AUDIO CONNECTION (polarity is not important) The centre 2 pins of the DS Controller RJ socket need to connect to the centre 2 positions of the DP2 Phoenix socket. POWER CONNECTION (polarity is not important) The 2 pins either side of the centre 2 pins of the DS Controller socket connect to the 2 outer positions of the 4 pin Phoenix socket.
- Page 13 SURFACE MOUNTING KITS Stainless Steel Surface Mounting Kits are available for the following Door Phones : DP2-V (Vertical), DP3-V (Vertical), DP3-H (Horizontal) and the DP5-V (Vertical) They allow your Door Phone to be quickly be mounted ONTO a wall surface, rather than into it.
-
Page 14: Door Phone Covers
COVERS FOR VERTICAL MOUNTED DOOR PHONES Model DPC1-V : for Model DP1 Door Phone Model DPC2-V : for Model DP2 Door Phone Model DPC3-V : for Model DP3 and DP5 COVERS FOR HORIZONTAL MOUNTED DOOR PHONES... - Page 15 Unit 11, 39 Lawrence Drive NERANG QLD 4211 AUSTRALIA Ph + 617 5596 5128 The Country Specific Power adaptor supplied with the Door Station Controller that powers this product complies with Australian (RCM), UL (USA) or cUL (Canada) specifications. Natcomm Page 15...
-
Page 16: Specifications
Damage caused to this device or attached equipment, by lightning strikes or over voltage surge is not covered under this warranty. UNIT SEALED AT THE FACTORY OPENING THE UNIT WILL VOID THE WARRANTY Page 16 Natcomm...