Page 1
Door Phone For Technical Assistance call the Manufacturers direct ph 0800 530 8645 9AM - 5PM West Coast Pacific Time NATCOMM USA LLC Supplier Code : NC...
DOOR PHONE COVER or a SURFACE MOUNTING KIT, which has a Rain Deflector should be used (see pages 14-15). Our DP2 Door Phones can operate at distances of up to 330 yards (300 meters) from the Controller, providing high quality cabling such as CAT3 or CAT5 is used.
Red LED Night illumination. (4 in Wide, 5.25 in High, 1.25 in Depth). (100mm Wide, 133mm High, 32mm Depth). Model DP2 - FLUSH MOUNT Compact Size Marine Grade Stainless Steel face plate. Touch Switch operation.
CONTROLLER where ADSL is used on the same line. If you do not do volume both directions will affected. Refer to your Door Station Controller User Guide for detailed information on the use of ADSL with this product. Page 6 Natcomm...
A Door Phone Balance Pot is located behind a sealing plug on the rear of DP2. Its position is Factory Set and will usually not have to be adjusted. For some installations (such as when using 2 Door Phones in parallel), it may be necessary to adjust the Balance Pot (see page 9).
(7.5 in x 3.4 in x 1.6 in) or (190mm, 85mm, D 40mm) SURFACE MOUNTING KITS Stainless Steel Surface Mounting Kits are available for all Model DP2 to DP5 Door Phones, so that your Door Phone can be mounted ONTO a wall surface, rather than into it.
PHONE, as feedback interference will affect the Balance Pot settings. 4) The Balance POT does not increase volume. Moving it when unnecessary may cause a deterioration in audio quality or a loss of audio in 1 direction. Natcomm Page 9...
LOCK 2 WHITE Supplied 8 wire ORANGE LOCK 1 LOCK 1 BROWN connection box for connection of BLACK POWER POWER YELLOW 1 or 2 Lock Release power supplies RED AUDIO AUDIO GREEN CAT5 CABLE or SOLID CORE CABLE Page 10 Natcomm...
Page 11
DOOR PHONE WIRING BLACK POWER POWER YELLOW AUDIO AUDIO GREEN CAT5 CABLE or SOLID CORE CABLE The colors used are those of the wires in the supplied Interface box. Natcomm Page 11...
Note : The polarity of the Audio signal and power connections is not important and can be reversed. Important Note : The colors referred to on this page and page 13 are those of the wires in the supplied interface box. Page 12 Natcomm...
Page 13
AUDIO CONNECTION (polarity is not important) The center 2 pins of the DS Controller RJ socket need to connect to the center 2 positions of the DP2 Phoenix socket. POWER CONNECTION (polarity is not important) The 2 pins either side of the center 2 pins of the DS Controller socket connect to the 2 outer positions of the 4 pin Phoenix socket.
Door Phone can be mounted ONTO a wall surface, rather than into it. Two separate surface mounting kits are available, to cater for the two different sized Door Phones (DP2-DP5) that can be mounted vertically. All kits have an integrated Rain Deflector. o Model SMK2 : for DP2 units...
COVERS FOR VERTICAL MOUNTED DOOR PHONES Model DPC1 : for Model DP1 Door Phones Model DPC2 : for Model DP2 DP1 Door Phones Model DPC3 : for Model DP4 & DP5 DP1 Door Phones Natcomm Page 15...
Damage caused to this device or attached equipment by lightning strikes or over voltage surge is not covered under this warranty. THE CASE IS SEALED AT THE FACTORY. OPENING THE CASE WILL VOID THE WARRANTY. Page 16 Natcomm...