Advertisement

Quick Links

DP1
DOOR PHONE
For Technical Assistance
Please Ph: 07 5596 5128
Page 1
Natcomm

Advertisement

Table of Contents
loading

Summary of Contents for NatComm DP1

  • Page 1 DOOR PHONE For Technical Assistance Please Ph: 07 5596 5128 Page 1 Natcomm...
  • Page 2 CONTROLLER. This allows for a DP1 to be located at two different locations. In this situation, the DP1 devices are connected in parallel. DP1 is designed for wall or pole mounting at a height of approximately 1.5 meters (5 feet). Visitors should stand within 0.5 meters (20 inches) of the Door Phone for best results.
  • Page 3: Door Phone Performance

    CONTROLLER where ADSL is used on the same line. If you do not do so, volume in both directions will be affected. Refer to your Door Station Controller User Guide for detailed information on the use of ADSL with this product. Page 3 Natcomm...
  • Page 4: Mounting The Door Phone

    The DOOR PHONE should be mounted at the average face height of 1.5 meter (5 feet) for optimum performance. The DP1 Surface Mount Door Phone unit is designed to be fitted onto a wall surface. This is done by separating the Door Phone unit from the integral backing plate which is secured by a screw under the bottom lip of the Door Phone.
  • Page 5: Wiring Connection

    GREEN wires should be connected to the centre terminals of the Phoenix connector on the rear of the DP1 unit and in the case of a 4 wire connection the BLACK and YELLOW wires connected to the outer two terminals of the Phoenix connector.
  • Page 6 DP1 Wiring Details 4 WIRE INSTALLATION: Use pins 4 & 5 of DS RJ Connector or RED & GREEN terminals of connector box + pins 3 & 6 of DS RJ Connector or BLACK & YELLOW terminals of connector box. Polarity is not important.
  • Page 7: Operation

    To test your Door Phone:  You will require two people – one to call and one to answer  Do Not use a telephone in very close proximity of the Door Phone as feedback will cause loss of volume. Page 7 Natcomm...
  • Page 8: Specifications

    Damage caused to this device or attached equipment, by lightning strikes or over voltage surge is not covered under this warranty. CASE SEALED AT FACTORY OPENING THE CASE VOIDS THE WARRANTY Page 8 Natcomm...

Table of Contents