Commercial Electric 5516-VN Installation Manual

PACKAGE CONTENTS
A- 15 in. Telecommunication Center
B- (4) Surface Mounting Brackets
C- (4) Surface Mounting Bracket Screws
D- (4) Screw Cover Screws
Flush Mount Installation
1
PLACING THE ENCLOSURE
Place the Telecommunications Center (A) in the install
□
location. For the flush mount install you will not need (B)
Surface Mounting Brackets or (C) Surface Mounting Bracket
Screws.
3
INSTALLING THE ENCLOSURE
□
Secure the two tabs to the studs using the included
Metal Wood Screws and a Phillips Head Screwdriver.
Safety Information
Please read all instructions and safety information before use.
Retain this manual for future reference.
CAUTION: When using tools always follow the
manufacturer's safety guidelines.
ETL LISTED
CONFORMS TO
UL STANDARD 2416
CERTIFIED TO
CSA STD C22.2 NO
5015295
60950-1
F- (4) Metal Wood Screws
2
□
A
4
□
F
D
NOTE: this enclosure is a distribution panel for low voltage
wiring systems. It is not designed to be used as an AC power
distribution panel. Use only Class 2 powered or passive devices.
Never install low voltage wiring during lightning storms. Never
install low voltage wiring in wet locations unless the wire is
specifically designed for wet locations
RoHS Compliant
Item # XXXXXXXXXX
Installation Guide
15 inch Telecommunication Center
TOOLS NEEDED
Phillips Head Screwdriver
Utility Knife
Pencil/Pen
Level
MARKING THE SCREW LOCATIONS
Make sure the Telecommunication Center is level and
mark the two screw locations on the studs using a pen or
pencil.
INSTALLING THE SCREW COVER
Once you have run wires and loaded the enclosure, you can
install the cardboard dust guard. Install the drywall over the
location. After sanding and paint you can remove the cardboard
dust guard. Complete installation by securing the cover (E) to the
enclosure using the included Cover Screws (D) and a Phillips
Head Screwdriver.
Model #5516-VN
E
Rev. 03/23/2020