Satel ATELLINE-M3-TR3 Integration Manual page 50

ModemInfo SL%3="data"
ModemInfo SL%4?
ModemInfo SL%4="data"
ModemInfo SL%D?
ModemInfo SL%H?
ModemInfo SL%S?
ModemInfo SL%V?
RadioFreq SL!D?
RadioFreq SL!U?
RadioFreq SL!W?
RadioFreq SL!Y?
RadioFreq SL&F?
RadioFreq SL&F=nnn.nnnn
n
RadioFreq SL&FR?
RadioFreq SL&FR=nnn.nnn
nn
RadioFreq SL&FT?
RadioFreq SL&FT=nnn.nnn
nn
RadioFreq SL&W?
RadioFreq SL&W=xxxx
RadioProperty SL%F?
RadioProperty SL%F=x
Set arbitrary data (max 25
characters) in memory location 3
Get arbitrary data stored in
memory location 4
Set arbitrary data (max 25
characters) in memory location 4
Get Modem Type
Get logic hardware version
Get Serial Number
Get firmware revision information
Get lower limit of frequency band 1
Get upper limit of frequency band
1
Get lower limit of frequency band 2
Get upper limit of frequency band
2
Get active frequency
Set active frequency to nnn.nnnnn
MHz
Get Rx frequency
Set Rx frequency to nnn.nnnnn
MHz
Get Tx frequency
Set Tx frequency to nnn.nnnnn
MHz
Get channel spacing/channel
width
Set channel spacing. Value of xxxx
is:
"1250" for 12,5 kHz
"2000" for 20 kHz
"2500" for 25 kHz
Before using this command, make
sure that active frequency matches
new channel spacing
Get status of Error correction (FEC)
Set Error correction (FEC). Value of
x is:
"1" Set FEC ON
"0" Set FEC OFF
49
SATELLINE-M3-TR3,
–TR4 and -R4
Integration Guide, Version 3.0
"OK" or "ERROR"
If empty data is stored,
response = "Undefined",
otherwise data and
carriage return
"OK" or "ERROR"
Depends on model, for
example "M3-TR3"
Hardware info
Serial number of radio
modem
For example
"V07.22.2.3.0.2"
"nnn.nnnnn MHz"
"nnn.nnnnn MHz"
"nnn.nnnnn MHz"
"nnn.nnnnn MHz"
"nnn.nnnnn MHz"
"OK" or "ERROR"
"nnn.nnnnn MHz"
"OK" or "ERROR"
"nnn.nnnnn MHz"
"OK" or "ERROR"
"25.0 kHz", "20kHz", "12.5
kHz"
"OK" or "ERROR"
"0" = FEC OFF , "1" = FEC
ON
"OK" or "ERROR"