Satel ATELLINE-M3-TR3 Integration Manual page 48

ChannelList SL$C?
ChannelList SL$C=nn
ChannelList SL$D?
ChannelList SL$D=n
ChannelList SL$E=1
ChannelList SL$F?
ChannelList SL$F=n
ChannelList SL$L?nn
ChannelList SL$L=Iaa,Nbbbb
bb,Fccc.cccccc,
Wdd.ddd,Peeee
e<CR>
ChannelList SL$M?
ChannelList SL$M=n
Get number of channels in channel
list
Set number of channels in channel
list. nn = 0...40, 0 clears the whole
list
Get channel list default channel
number
Set channel list default channel, n
is channel number
Search free channel
Modem searches for next traffic-
free channel. Listening time of
traffic is about 2 seconds
Modem shows next free channel by
activating command again
Get active channel number
Set modem to channel number n in
channel list
Get channel info.
Index nn=[0...(number of channels-
1)]
I = Index field aa = 0...39 //Future
reservation 0...255
N = Channel number field bbbbbb
= -32767...32767
F = Tx/Rx Frequency field
ccc.cccccc = Tx/Rx Frequency in
MHz (only numbers or "." allowed,
"," is not allowed)
W = Channel spacing/width field
ddddd = 12.5, 20 or 25 (unit is kHz,
trailing decimals are tolerated e.g.
"25", "25.0", "25.00" and "25.000"
are all valid)
P = Transmitter power field eeeee =
0...35000 (modem rounds the value
to the closest applicable) Note: 0
means "don't care" value for
power.
<CR> = Carriage return character
Get status of channel list. 0 = Not in
use, 1 = Channel list in use
Set status of channel list. 0 = Not in
use, 1 = Channel list in use
47
SATELLINE-M3-TR3,
–TR4 and -R4
Integration Guide, Version 3.0
decimal number
"OK" or "ERROR"
decimal number
"OK" or "ERROR"
"OK" followed by "channel
n is free"
Value of n is channel
number of next free
channel on channel list
decimal number
"OK" or "ERROR"
Channel number,
Frequency, Channel width,
Tx Power
For example: "CH 1,
430.150000 MHz, 25.0 kHz,
100 mW\0D"
"OK" or "ERROR"
"0" or "1"
"OK"