Table of Contents
Advertisement
JUMPER SETTING AND CONNECTORS
CPU T
S
I
P
EMPERATURE
ENSOR
NSTALLATION
RCESS
1. Put the temperature sensor in the rivet hole of heat sink on CPU.
2. Adhered the holder to heat sink.
3. Put the wire on the holder and buckle the clip.
4. Place 2-pin female connector on TMR2 2-pin male header.
2.3 J
S
O
UMPER
ETTING
VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on
the your SBC to match the need of your application. To set a jumper, a black plastic
cap containing metal contacts is placed over the jumper pins as designated by the
required configuration as listed in this section. A jumper is said to be " on " or " 1-2 "
when the black cap has been placed on two of its pins, as show in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local sales representative before you make any changes. In general, you simply need
a standard cable to make most connections.
AP-687VF/F 8
Downloaded from StockCheck.com
Advertisement
Table of Contents
