Table of Contents
Advertisement
JUMPER SETTING AND CONNECTORS
I
NSTALLING THE
A DIM module simply snaps into a socket on the system board. Pin1 of the DIM module
must correspond with Pin1 of the socket.
Tab
Pin1
1. Pull the "tabs" which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the "notches" in the module aligned with the
"keys" on the socket.
3. Seat the module vertically into the socket. Make sure it is completely seated. The
tabs
will hold the DIMM in place.
I
N
NSTALLING
1. Hold the SBC with the PCB component side facing you in an angle of 75° at a
distance 30cm.
TM
2. Slide Celeron
socket, until a "click" sound is produced by the connection between the gold fingers
and connector pins.
TM
3. The Celeron
Processor is loosely withstanding against the Slot 1 connector, now
secure the guides of the latch pins (one at a time) to the edges of the CPU heat sink,
until a "click" sound is produced by the key against key way. Please take note the
retention modules and latch clippers have the left and right orientation marked on the
surface of the material.
R
EMOVING THE
1. With the component side of SBC facing you, push the spring of the latch clipper(s)
from right to left for the left latch clipper and vice-versa for right latch clipper.
Downloaded from StockCheck.com
DIM M
ODULE
Notch
Key
Celeron
OTES FOR
Processor against the left and right retention module to the Slot 1
L
C
ATCH
LIPPERS
AP-687VF/F 6
:
TM
P
ROCESSOR
Tab
:
Advertisement
Table of Contents
