Download
Share
Print this page
MERLYN 8 Series Installation Manual
  1. Manuals
  2. Brands
  3. MERLYN Manuals
  4. Bathroom Fixtures
  5. 8 Series
  6. Installation manual

MERLYN 8 Series Installation Manual

Hide thumbs Also See for 8 Series:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Hinge Door

Advertisement

loading
Need help?

Need help?

Do you have a question about the 8 Series and is the answer not in the manual?

Questions and answers

Related Manuals for MERLYN 8 Series

Summary of Contents for MERLYN 8 Series

  • Page 1 Hinge Door...
  • Page 2 COMPONENTS AND BOX CONTENTS Description Part No. Wall profile cover caps screw 8S410045 Upright profile cover cap 8SSJ035L/R Wall profile cover cap 8SSJ036L/R Wall plug 8SSJ066 Wall profile 8SALMJ9071 Handle complete inside & outside 8SCU056B Wall fixing screw(4x30) 16 8S410044 Moving panel Trim strip 8SAL0002...
  • Page 3 FIXING KIT COMPONENTS, TOOLS REQUIRED, SITE CONDITIONS Fixing Kit components parts shown are not to scale 2.5mm 8SSJ035L 8SSJ035R 8S1300511 8S1301152 8SSJ036L 8SSJ036R 8SSJ036L 8SSJ036R 8SCU0561 8SCU0562B 8SCU0563B 8SCU0564 8SCU0565 8SCU0566 4*30 4*12 2.7*12 8S410047 8S410044 8S410045 8SSJ066 8SSJ059 Tools required - 6mm masonry drill bit - Power drill - Quality silicone...
  • Page 4 POSITIONING OF WALL PROFILES TRAY MUST BE 100% LEVEL IN ALL DIRECTIONS Ensure the shower tray is level in all directions and is properly sealed to the wall. The wall must be tiled down to the top edge of the tray. Do not angle out bottom tile. TRAY MUST BE SEALED FULLY AROUND WHERE THE TRAY MEETS THE WALL.
  • Page 5 FIXING WALL PROFILES TO WALL Step 5 Slot wall profiles into door frame, then lift door onto the tray. Step 6 Fix the wall profile to the wall with screws 8S410044. Step 7 Adjust the door panel until it is adjusted evenly between both wall profiles.
  • Page 6 FIXING FRAME TO WALL PROFILES Step 10 The door panel when closing should meet the top and bottom ball catches at the Step 8 same time. If not, loosen the Drill 5 equally spaced holes screw fixing the wall profile with 3mm drill bit 8S1301152 to the wall and adjust the top through the nylon clip...
  • Page 7 FITTING COVER CAPS AND HANDLE, SEALING Step 14 Assemble handle onto moving panel A. Insert the brass screws 8SCU0563B through the glass from the inside and screw into the outer handle 8SCU0561 (without grub screws). Do not over tighten . Ensure all washers are present on both sides of the glass.

  • Page 8: Troubleshooting Guide

    Trouble Shooting Guide Hinge Door ① Do the finished measurements on the tray comply with the adjustments listed in the product specifications book? ② Is the tray level and secured? (See page 3) ③ Are the wall profiles stepped in the recommended 20mm? (See step 1) ④...

This manual is also suitable for:

Hinge door