English
If the branch (house/shop) circuit breaker trips
repeatedly:
•
unplug or turn off other devices sharing the circuit with the
planer OR use the planer on another branch circuit by itself.
•
check for dull knives. Dull knives could cause
motor overloading.
•
reduce depth of cut. An overly aggressive cut could cause
motor overloading.
•
drop feed rate to 4.3 m/min (14 ft/min). A reduction in
feed rate will reduce the load on the motor and prevent
breaker trips.
nOTE: Even under normal loading conditions, other electrical
loads on the same branch circuit may cause the circuit breaker
to trip.
14