Mounting Connector Box; Connecting Wires - Cobra SoundTracker INTL75 Operating Instructions Manual

INTL75ST-English-UK.qx 6/16/99 10:13 AM
INSTALLATION
CONNECTOR BOX LOCATION
7
MOUNTING
CONNECTOR BOX
1. Hold Cobra INTL75ST
Connector Box in exact
location desired for
mounting.
2. Using it as a template,
mark the location for
the mounting screws
(included).
NOTE: Make certain that
nothing will interfere with
the installation of the
mounting screws, before
drilling holes.
3. Mount Connector Box
as shown.
MOUNTING
THROUGH FRONT
BULKHEAD
1. Drill hole through
bulkhead.
2. Bolt plate and grommet to
bulkhead.
3. Push cable through
grommet.
Page 12
The INTL75ST is designed for 12 VDC, negative ground vehicles only.
CAUTION: If the INTL75ST is connected to a constant 12-volt source,
leaving it switched on after the engine is turned off may drain
the car battery. If the INTL75ST is connected to an accessory
12-volt source, it will switch off when the engine is turned off,
and reset to Channel 1.
INSTALLATION
CONNECTOR BOX

CONNECTING WIRES

1. Connect the antenna
cable connector.
2. Connect the red wire
marked "BATT" (+)
directly to the positive
side of the battery or to a
connection on the fuse-
box that is always live.
3. Connect the black wire
marked (-) "Earth" to the
negative side of the car,
usually the chassis. Any
other location with good
electrical contact (paint
removed) will
also work.
8