LG Minibeam Nano PV150G Owner's Manual page 101

4
SAFETY PRECAUTIONS
• Do not place the projector in direct
sunlight or near heat sources such as
radiators, fires, stoves, etc.
- This may result in fire.
• Do not place flammable materials
such as aerosols near the projector.
- This may result in fire.
• Do not allow children to cling to or
climb up to the projector.
- This may cause the projector to
fall, causing injury or death.
• Do not install the product in a
place with no ventilation (e.g., on
a bookshelf or in a closet) or on a
carpet or cushion.
- This may result in fire due to the
increase in internal temperature.
• Do not place the product close to
sources of steam, oil or oil mist, such
as humidifiers and kitchen counters.
- Failure to do so may result in fire,
electric shock, or corrosion.
• Do not install the product onto a wall
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged
and fall, resulting in serious injury.
• Do not place the projector where it
might be exposed to dust.
- This may result in fire.
• Do not use the projector in a damp
place such as a bathroom where it is
likely to get wet.
- This may result in fire or electric
shock.
• Do not allow a tablecloth or curtain to
block the air vent.
- This may result in fire due to
the increase in the internal
temperature.
• Ensure good ventilation around the
projector. The distance between the
projector and the wall should be at
least 30 cm.
- This will prevent fire due to
the increase in the internal
temperature.
CAUTION
• When placing the projector on a table
or shelf, be careful not to put it near
the edge.
- The projector could fall due to
bal ance problems, which may
cause personal injury or damage
to the product. Make sure to use
the pro jector cabinet or stand that
fits the projector.
• When moving the projector, make
sure to switch it off and remove the
power plug and cords.