Menu #3 - Remote Start Features
Feature
One Chirp
Number
Setting
3-1
Engine checking ON
3-2
Engine checking TACH
3-3
Run time: 12 minutes
3-4
Parking lights flashing
3-5
Crank time 0.6 seconds
3-6
Votage check - high
3-7
Auxiliary output - factory disarm
3-8
Status output
3-9
Anti-grind ON
Feature Descriptions
The features of the system are described below. Features that have additional settings that can be
selected only when programming with the 998T Bitwriter are indicated by the following
icon:
Menu #1 - Basic Features
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when
the transmitter is used. When set to passive, the system will arm automatically 30 seconds after the
last door is closed. To alert the consumer of passive arming, the siren will chirp 20 seconds after the
door is closed. This provides the consumer with an audible warning prior to the system actually
arming. At the 30 second mark, the system will arm, but the siren will not chirp.
1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of
the system.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors
will lock three seconds after the ignition is turned on and unlock when the ignition is
turned off. The 998T Bitwriter™ will display separate steps for ignition lock and ignition
unlock. They can be programmed on or off independently.
1-4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1-1, then the system can
be programmed to either lock the doors when passive arming occurs, or only lock the doors when
the system is armed via the transmitter. Active locking means the system will not lock the doors when
it passively arms. Passive locking means that the system will lock the doors when it passively arms.
26
Two-Chirp
Setting
Engine checking OFF
Engine checking VOLTAGE
Run time: 24 or 60 minutes
Parking lights constant
0.8, 1.0, 1.2, 1.6, 1.8, 2.0, 4.0
Voltage check - low
Special accessory
Factory re-arm output
Anti-grind OFF
©
2002
Directed Electronics, Inc.
Need help?
Do you have a question about the 554R and is the answer not in the manual?
Questions and answers