Section
11
12) PERIODIC MAINTENANCE
Maintenance should be performed at least once a year. More often if your tracker is installed in severe
♦
weather areas.
Inspect all the tracker hardware and the module bolts for tightness. Tighten all nuts and bolts that need it.
♦
Inspect all wires for abrasion and gently tug on them to make sure that they are secure.
♦
Each of the four grease zerks should receive 4-6 pumps of lithium-base general-purpose chassis grease from
♦
a grease gun.
Elevation Actuator: Spray the inner tube (telescoping part) of the linear actuator with a lubricating rust inhibitor.
♦
(We use LPS-3)
NOTE:
YOUR AZ-225 GEAR DIVE MAY HAVE THE 4
HOUSING RATHER THAN THE TOP AS SHOWN IN THE PICTURE.
Periodic Maintenance
th
GREASE ZERK LOCATED ON THE BOTTOM OF THE GEAR
33