Table of Contents
Advertisement
Step 6
Pull the module rail u-bolts, washers and locknuts
from the hardware kit. There will be one set of u-bolt
hardware per module rail.
If your module rail is longer than 10 feet then there
will be a corresponding support angle in your frame
bundle.
Step 7
If you have a three column tracker
(3 modules wide) then your first rail set will be
centered over the drive head and straddle the
centerline of the torque tube.
If you have a four column tracker ( 4 modules wide)
then your first rail set will be to the right or left of the
centerline of the torque tube.
(Step 1)
Step 8
Pass the u-bolt through the holes in the support
angle. Push the u-bolt up and around the torque tube
and into the receiving holes in the bottom of the
module rail.
Place a 1/2" flat washer over each leg of the u-bolt
and then secure a 1/2" Nylock nut over each leg. Do
not tighten the Nylock nut completely. Leave a little
slack so the rail assembly can be slid horizontally
along the torque tube to accommodate your "center
to center" measurement.
(Step 4)
15
Hide quick links:
Advertisement
Table of Contents
