Wattsun AZ-225 Installation Manual page 22

5.1) THE AZMUTH MOTOR TERMINAL STRIP (PRE-WIRED AT THE FACTORY)
It is unlikely that you will need to access the wiring inside the Azimuth Motor. The Azimuth Motor Terminal
Strip is pre-wired at the factory. It serves as a central connection point for motor power wires. The 4-wire
Controller output lead and the Elevation Actuator lead share entry into the Azimuth Motor Cover through
the rain tight plastic strain relief.
A four-wire lead enters in from the Controller and is divided into two pairs. The first pair (White & Green)
controls the East-West Azimuth movement. The second pair (Red & Black) "passes through" and controls
the North-South elevation movement. The Elevation Actuator power lead exits azimuth motor cover
through the strain relief and will be connected to the actuator motor by the installer.
.
AZ-225 AZIMUTH MOTOR WIRE CONNECTIONS
22