Table of Contents
Advertisement
EVOLVE Portable Column Loudspeaker
6.
7.
8.
9.
10. MAINS IN – The device receives its power supply via the MAINS IN socket. Only the
11. POWER - AC switch for switching the power ON or OFF. The LCD screen lights up when
Notice!
i
Markings and statements on amplifier panel may vary.
Electro-Voice
connection of stereo line level signals. Connection is made using either two XLR-type,
TRS, RCA, or a single 1/8th inch stereo connector. Input 7/8 is reserved for stereo
Bluetooth audio connection.
MIX OUT - The post-fader audio signals of INPUT 1 through INPUT 7/8 are mixed and
passed to MIX OUT. The ratio of the input signals changes when the level controls INPUT
1 - 7/8 are adjusted. This feature allows the loudspeaker to act as a basic eight-channel
mixer that can send the mix to another loudspeaker via the MIX OUT socket. The output is
configurable in the menu to provide either the Mixer Mono, Stereo left or Stereo right
signal. If QuickSmart Link is used, MIX OUT provides the same signal as the column
system.
AUX OUT - The AUX OUT is configurable to provide either a separate post fader audio mix
of INPUT1 - 7/8 (controlled by individual channel AUX levels adjustable in DSP) or the
main mix output signal. In the case of main mix, the full mix including effects is provided
whereas the separate aux mix comes without effects.
QuickSmart Link - RJ45 connector for Cat5 cable to link two EVOLVE 50M systems
together for digital audio and system control. QuickSmart Link should only be used to
connect two EVOLVE 50M systems. QuickSmart Link is not an Ethernet/LAN port and is
not compatible with network devices.
FOOT SWITCH - ON/OFF control of DSP user selectable audio FX.
provided power cord may be used. Connect the device only to a mains network, which
corresponds to the requirements indicated on the type plate.
the power is turned ON, after approximately 1 second.
10
User manual
Amplifier DSP | en
11
2020-12 | v01 | F.01U.393.750
15
Advertisement
Table of Contents
