Radio Shack ADV0801 Owner's Manual page 74

ADV0801 Owner's Manual Draft
Zeromatic
Search Dir
Hit Count
STLK Menu Reference
The STLK menu is used when creating new Signal Stalker II objects, or editing existing Signal
Stalker II objects. All menus are shown in the scanner's display as a three line window that can
be scrolled up or down to access the various different parameters. The active parameter is
always the middle parameter and is indicated by a flashing ":". The entire STLK menu is shown
below:
STLK Parameter
Scan Lists
Type
Sub-bands
On or Off
When on, enhances the scanner's ability to lock on to the
actual center frequency of a search hit instead of an
adjacent frequency.
Up or Down
Sets search direction used when SRVC object is active.
Numeric value
Increments each time a transmission is received on the
SRVC object. Global "Hit Counts" must be set to ON. Press
the Dflt softkey to reset to 0.
Options Description
On or Off for Scan Lists 1-20
Sets membership in Scan Lists. Use < > keys to scroll
through Scan Lists. Use SEL key to toggle Scan List
membership. A "*" next to the Scan List number indicates
that the object is mapped to that Scan List.
All Bands or Pub Safety
Use < > to select All Bands or Public Safety. All Bands
covers the entire frequency range of the scanner. Public
Safety covers frequency ranges commonly used for public
safety communications.
< > , SEL
Sub bands are available when using STLK in All Bands or
Public Safety mode. In All Bands, the sub bands are
defined as follows:
0: 25-54 MHz
1: 108-137 MHz
2: 137-174 MHz
3: 216-300 MHz
4: 300-406 MHz
5: 406-470 MHz
6: 470-512 MHz
Page 74