Table of Contents
Advertisement
Mounting a Drive in a Drive Carrier
1. Release and swing open the locking latches on the side of the drive carrier.
2. Insert a drive into the carrier with the PCB side facing down and the connector end
toward the rear of the carrier. Insert the drive at an angle as shown in Figure 3-7. Verify
that the mounting holes on the drive align with the mounting holes on the carrier.
3. Swing both locking latches shut. An audible click indicates that the drive is locked in
place.
4. Insert the drive and drive carrier into its bay. When the drive is fully inserted, push the
release tab until it clicks shut. Refer to Figure 3-8.
1
2
1
1
Figure 3-8. Installing a Drive Carrier into the Sled
Chapter 3: Maintenance and Component Installation
Figure 3-7. Mounting a Drive in a Carrier
1
4
53
1
3
Advertisement
Table of Contents
