Creating The Non-F Model Processor Carrier Assembly - Supermicro SuperServer 1029P-N32R User Manual

Creating the Non-F Model Processor Carrier Assembly

To install a Non-F model processor into the processor carrier, follow the steps below:
1. Hold the processor with the LGA lands (gold contacts) facing up. Locate the small, gold
triangle in the corner of the processor and the corresponding hollowed triangle on the
processor carrier. These triangles indicate pin 1. See the images below.
2. Using the triangles as a guide, carefully align and place Point A of the processor into
Point A of the carrier. Then gently flex the other side of the carrier for the processor to fit
into Point B.
3. Examine all corners to ensure that the processor is firmly attached to the carrier.
Align Point A of the CPU and
Point A of the Processor Carrier
Chapter 3: Maintenance and Component Installation
B
CPU (Upside Down)
with CPU LGA Lands up
A
Pin 1
A
Align CPU Pin 1
A
Allow carrier to
latch onto CPU
Pin 1
Processor Carrier Assembly (Non-F Model)
31
Align Point B of the CPU and
Point B of the Processor Carrier
B
Processor Carrier
(Upside Down)
Allow carrier to
latch onto CPU
B