Summary of Contents for CyberPower STANDBY UPS Series
Page 1
YOUR ULTIMATE ALLY IN POWER STANDBY UPS SERIES SE450G1 / SX650U / SX950U USER MANUAL SE450G1 SX650U SX950U FEATURES Power On Switch 5. Circuit Breaker 2. Power On Indicator (green) 6. USB Port to PC (except for SE450G1) 3. Battery and Surge Protected Outlets 7.
PRODUCT REGISTRATION Thank you for purchasing a CyberPower product. This UPS is designed to provide unsurpassed power protection, operation, and performance during the lifetime of the product. Please take a few minutes to register your product at: www.CyberPowerSystems.com/registration. Registration certifies your product’s warranty, confirms your ownership in the event of a product loss or theft, and entitles you to free technical support.
INSTALLING YOUR UPS SYSTEM UNPACKING 3. Plug the UPS into a 2-pole, 3-wire ground- ed receptacle (wall outlet). Make sure the Inspect the UPS upon receipt. wall branch outlet is protected by a fuse or The box should contain the following: circuit breaker and does not service equip- (a) UPS unit ment with large electrical demands (e.g.
BASIC OPERATION 1. Power On Switch or other large electrical device into the “Battery and Surge Protected Outlets.” To turn the UPS on, press the power button The power demands of these devices will for approximately 2 seconds - you will hear overload and possibly damage the unit.) a constant tone (1 second) - and release 4.
UPS on. Recharge the battery by leaving the UPS Battery not fully charged. plugged in. The UPS does not perform Contact CyberPower Systems about expected runtime. Battery is worn out. replacement batteries at: cyberpower- systems.com/support. The on/off switch is designed to prevent Turn the UPS off.