Table of Contents
Advertisement
Wired remote controller installation
Tracking Hydro Unit from a wired remote controller
The number of Hydro Unit currently detected
1. Tracking of your wired remote controller will automatically start when you turn on the power after installation.
2. If you want to perform tracking again after installation, press the Esc and Delete buttons at the same time for more
than 5 seconds.
f The system will reset, and tracking will start again.
3. During the tracking, the total number of currently searched Hydro Unit will be displayed.
• If you want to do system reset for your wired remote controller, press the Esc and Delete buttons at the same
time for more than 5 seconds.
CAUTION
• Only the master wired remote controller can display the total number of Hydro Units.
- Slave wired remote controllers do not display the total number of Hydro Units.
8
DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 8
Display tracking is
being performed.
2013-01-09 오후 2:48:40
Advertisement
Table of Contents
