Table of Contents
Advertisement
Wired Remote Controller Installation
3. Using more than two screws, firmly affix the rear cover of the remote controller to the wall, and then connect the
power(V1, V2) and communication cables(F3, F4), making sure these cables have reasonable length, to the terminal at
the back of the cover.
10mm (0.4 inch) or more
10mm (0.4 inch)
or more
50mm (2 inch) or more
❋ Before fixing the rear cover, allow
at least 10mm(0.4 inch) space of
upper side, left side, right side, and
50mm(2inch) space of bottom side.
4. Reassemble your wired remote controller.
• Align the controller with the upper groove first, and insert it by turning it downward as shown in the
figure. After assembly, check and confirm that no wires are stuck in the gap between the rear and
NOTE
front cover.
6
DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 6
10mm (0.4 inch) or more
Screw hole
Rear cover
❋ You must fit the screws into the
screw holes.
Hydro Unit
Hydro Unit
PCB
Wire (not supplied)
Wired remote
controller
PCB terminal
Front cover
❋ Do not tighten the screws on the
PCB terminal with excessive force.
2013-01-09 오후 2:48:40
Advertisement
Table of Contents
