Table of Contents
Advertisement
Use of field specification checking mode
Data
Address of field specification
1. If you want to use the field specification checking mode for your wired remote controller, press the Set and [∧]
buttons at the same time for more than 3 seconds.
2. You can check the setting value of the field setting address as follows.
f Using the [∧]/[∨] buttons, move to the field specification address you want to check.
f Using the [∧] button, move to the next address.
f Using the [∧] button, move to the previous address.
f Press the ESC button to exit to normal mode.
• When you don't enter any buttons for more than 3 minutes, you will be back to normal mode.
NOTE
23
DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 23
2013-01-09 오후 2:48:44
Advertisement
Table of Contents
