Table of Contents
Advertisement
• When installing a wired remote controller by using a cable longer than 10m, you must install the
communication cable and the power cable separately. (Electrical interference can cause your wired remote
CAUTION
controller to malfunction.)
• When installing your wired remote controller on the wall, consider the size of the wire hole, and select a wire
with a proper thickness.
• Wire that is connectable to wired remote controller PCB.
- If you install the wired remote controller by reclaiming, install it according to U-terminal cable specification.
- If you install the wired remote controller by using four pieces of PVC wire, remove the 30cm(12inch) of the
sheath of the cable and install it only with the four pieces of wires. (Recommended specification: AWG21)
- The followings are the specs of the compressed ring terminal connectable to your wired remote controller PCB
W
Stud
F
L
t
- Screws on the PCB terminal must be tightened with less than 6N•m tightening torque. If the tightening torque
is greater, it may damage the screw thread.
DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 7
Range of Permitted
Wires
AWG
mm
2
E
22~16
0.25 ~ 1.65
D
G
❋ Maximum distance for connection between communication cable and power
cable: 100m
Rated Size Stud Size
mm
mm
t
øD
2
1.5
3
0.7
3.8 10.0 4.5
Basic Size (mm)
G
E
F
W
L
6.5
6.0 21.2
7
2013-01-09 오후 2:48:40
Advertisement
Table of Contents
