Light Switch - Yamaha Wolverine X2 Owner's Manual

To limit vehicle top speed
1. Turn the main switch to "
2. Remove the hood. (See page 9-10.)
3. Insert the system key into the Speed
Management System switch and turn it
to " ".
4. Remove the system key.
5. Install the hood.
6. Turn the main switch to "
confirm that the speed management icon
comes on. (See page 5-10.)
TIP
The main switch must be turned to "
and then back to "
Management System changes are recog-
nized by the vehicle.
EWB04210
WARNING
Before using the system key, stop the en-
gine.
" (off).
" (on) and
" (off)
" (on) before Speed
Remove the system key immediately after
use, otherwise the switch may change po-
sitions when driving over bumpy roads or
fall out and be lost.
EBU31391

Light switch "

1
1. Light switch " /
Set the switch to "
beam and the taillights.
Set the switch to "
beam and the taillights.
Set the switch to "
lights and taillights.
5-14
/ / "
L
H
/ "
L H
" to turn on the low
L
" to turn on the high
H
" to turn off the head-
5