Table of Contents
Advertisement
D
ELEVATOR
Step 1: Find the Gear Box and
attach the shaft.
Step 4: Connect 1 Rail
Clip to each Elevator
Ring. Make sure
brackets on elevator
ring are right side up.
Step 5: Place the 3 Elevator
Rings onto the Shafts.
Spacerail ©2021
NOTE:
There should not be any
space between the Gear
Box and the Helix. If the
Helix is not installed
correctly the Elevator will
not run.
Step 2: Find the Elevator Helix
pieces and connect each
piece along the shaft.
Step 6: Place the Elevator Cap onto
the top of the elevator assembly.
Step 3: Once the
Corkscrew is built, attach
3 support shafts to the
Gear Box.
NOTE:
The Steel Marble will fall
out of the elevator if it
enters too fast.
Step 7: Attach the 3 Elevator Guards
to each of the Elevator Rings.
Advertisement
Table of Contents
