Table of Contents
Advertisement
Push "Y+/-" key to move the green block to the anticipant item, and when the green block is on
"enable" items, push "Enter" key to enable or disable the item, when enabled, the small diamonds is green,
and when disabled, the small diamonds is grey. When the green block is on the "Set origin" item or the
"Next origin" item, push the "X+-" keys to select the value.
Pay attention to if when the green block is on the "Set origin" item, push the "X+-" keys to select a
value, then, "Enter" key must be pushed to valid the change, or, the change is invalid.
Each item introduced as below:
Multiple Origins Enable: "Yes" or "No" can be selected. If you select "No", the system
will use the single-origin logic. You can press the "Origin" key and set the origin, and only this
origin can become valid. If you select "Yes", the system will use the multiple- origin logic and the
"Origin" key on the keyboard become invalid. In such a case, the parameter of each origin must
be set in the menu as follows.
Origin Enable1/2/3/4: after the multiple-origin logic is enabled, the four origins can
independently be prohibited and enabled.
Set Origin 1/2/3/4: after the multiple- origin logic is enabled, you can stop the cursor
at "Set as Origin 1/2/3/4". Press the "Enter" key on the keyboard and the system will take the
coordinate figures of current X/Y axles as the corresponding ones to the origin 1/2/3/4.
Next Origin: there are such five digits as 0~4 for option, which are the origins to be
used for the next figure. Origin 0 means the origin set by the "Origin" key on the panel in the
single- origin logic. 1~4 means the serial number of the origins in the multiple- origin logic. Next
origin can be modified to any one of origin 1~4, so as to control the start location of next work
(the premise is that the origin is enabled), but it can't be modified to origin 0.
of the next origin is 1 and four origins are enabled, when the memory
Prompt
file function is started or the processing file is uploaded into the PC
and this file selects "Take the Original Origin as current Origin", the
work started for each time will use different origins. The rotation order
SHENZHEN RUIDA TECHNOLOGY
Figure 4.14
Once the multiple- origin logic is selected and if the serial number
RDC5121 Control System Manual
20
Advertisement
Table of Contents
