Table of Contents
Advertisement
Push the "Y+/-" Keys to move the cursor to one of the entry, then push "Enter" key to restart the
selected axis, the screen will show some information when resetting.
4.3.2 ManualSet+
When the cursor is on this item, push the "Enter" key to show as below:
Push "Y+/-" key to move the cursor, and when the green block is on the "Mode" item, push "Y+/-"keys
to select the anticipant value, "Continue" or "Manual". When "Continue"
"Manual" item is not valid, on that time, push the direction keys to move the corresponding axes, and
when the pushed key is loosed, then the corresponding axes will finish moving. When the Mode item is
"manual", then pushing the direction key one time, the corresponding axes will move a fixed length,
unless the scope is overstepped.
4.3.3 Mechanical Para
When the item is selected, it is displayed as follows:
SHENZHEN RUIDA TECHNOLOGY
Figure 4.10
Figure 4.11
Figure 4.12
RDC5121 Control System Manual
item is selected,
then the
18
Advertisement
Table of Contents
