Table of Contents
Advertisement
Feeder (ADF-J1)
Place a stack of originals in the feeder, and press [Start]. The machine
automatically scans them into memory.
You can place the following originals in the original supply tray:
•
Weight: 10 to 32 lb bond (37 to 128 g/m
1
Size: 11'' ✕ 17'' , LGL , LTR , LTR , or STMT .
•
•
Tray Capacity: 50 sheets (20 lb bond [80 g/m
IMPORTANT
•
Do not place the following types of originals in the feeder:
- Originals with tears or large binding holes
- Severely curled originals or originals with sharp folds
- Clipped or stapled originals
- Carbon backed paper or other originals which might not feed smoothly
- Transparencies and other highly transparent originals
• Avoid scanning the same original using the feeder more than approximately 30 times.
Scanning the same original repeatedly may result in the original becoming folded or torn,
which in turn could cause a paper jam.
• If the feeder rollers are dirty from scanning an original written in pencil, perform the
feeder cleaning procedure. (See Chapter 7, "Routine Maintenance," in the Reference
Guide.)
1
1-14
Placing Originals
Place very thin originals 10 to 14 lb bond (37 to 51 g/m
originals 28 to 32 lb bond (105 to 128 g/m
25 sheets (11 lb bond [40 g/m
Neatly place your originals face up in the original supply tray.
If you are enlarging LTR originals to 11'' x 17'' or LGL paper, place your originals
horizontally.
Place your originals as far into the feeder as they will go.
A beep sounds when the originals are set correctly.
)
2
2
) into the feeder one at a time.
])
2
] or less)
2
), or very thick
2
Advertisement
Table of Contents
