Advertisement
6
Flat edge
Flat edge
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
- Fasten the BRACE (J) to the DRAWER UPRIGHT (C). Tighten the TWIST-LOCK
the BRACE.
NOTE:
Be sure the surface of the BRACE with TWIST-LOCK
sure the SKIRT is positioned as shown. Be sure the flat edge of the DRAWER UPRIGHT is
facing as shown. Follow the diagram.
- Fasten the BACK (F) to the DRAWER UPRIGHT (C). Tighten the TWIST-LOCK
NOTE:
Be sure the unfinished surface of the BACK is facing as shown. Follow the diagram.
- Fasten the DRAWER END (B) to the BACK (F) and BRACE (J). Tighten the TWIST-LOCK
the BACK and BRACE.
NOTE:
Be sure the finished surface of the DRAWER END is facing up. Be sure the flat edge of the
DRAWER END is facing as shown. Follow the diagram.
1034--290D
DRAWER
END (B)
Finished
surface
DRAWER
UPRIGHT (C)
SKIRT (I)
hole of the adjoining part while locking the FASTENER.
1- -800- -523- -3987
DRAWERS ON THE RIGHT
BACK (F)
Unfinished
surface
BRACE (J)
R
FASTENER (Refer to the enlarged diagram.)
R
FASTENERS is facing as shown. Be
Customer Service
Tighten the FASTENER
as tight as possible.
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
R
FASTENERS in
R
FASTENERS in the BACK.
R
FASTENERS in
Advertisement
