Home" "Sleep" "Away" Settings; Schedule Settings - Carrier User interface Comfort Module Series User And Installation Manual

Programming the user interface

"Home" "sleep" "away" settings

1. Select the desidered zone with
function.
2 Press and hold the comfort button
( or or
seconds. The set temperature, and the symbol heat (
or cool ( ) or domestic water ( ) will flash.
3 Press the mode ( ) button to switch between heat (
cool ( ) and sanitary ( ) (depend on access level).
4 Press the up or down button to set the desired
temperature set point for the selected mode. The
triangle icon ( ) above the pressed comfort button
( ) will start flashing.
5 Press again the up or down button to set the new
desired temperature setting for the next setting.
6 Pressing one of the other "home", "sleep", "away"
button, and replay step 4 to 5.
7 Press OK button to confirm changes and to exit from
the Comfort change mode.
8 If needed select a different zone and repeat steps 1.
The factory setting are show above
Touch 'N' Go Option
Home
Away
Sleep

Schedule settings

The schedule works on 4 different periods, called P1, P2, P3,
P4. Each zone has its own schedule. Using master board is
possible to set the schedule for sanitary and system.
key or virtual zoning
) to be changed for about five
Heat
20° C
15° C
18° C
)
),
Cool
24° C
28° C
26° C
The thermostat has preset settings (see below), but you can
change these.
Using the "virtual zone" feature (only for access level 3 and
master board) , it's possible to change the schedules of all
the zones in the installation.
Domestic hot water
60° C
50° C
Not available
7