Advertisement
Installation:
•
Verify that all peripherals and computers
are turned OFF prior to connecting them to
the product.
•
Connect the computers and peripherals to
the HSL Combiner as shown in the above
diagram.
•
The 8 and 16 ports combiners are designed
to be mounted in a rack hence will not be
in sight of the user. To control the
combiners use HSL's AFP and AFP splitters
(included with the product) based on the
above system diagram.
SC82PH-4
d
c
a
b
SC162PH-4
a
b
j
k
l
AFP Splitter WX12N-4
Rear Panel LED Indications:
HID LEDs (rear panel):
•
Off – no device detected
•
Flicker – device rejected
•
On- device approved
©2019 All rights reserved. HSL logo and product names are trademarks or service trademarks of HighSecLabs Ltd (HSL).
All other marks are the property of their respective owners. Images for demonstration purposes only.
•
Power ON the monitors and the PCs:
Make sure that the monitors and the
connected PCs are turned ON prior to
powering ON the Combiner.
•
Power ON the system: Power ON the
Combiner by plugging it to the AC wall
outlet and press the Power button (k) (for
16 ports connect two power cords to the
unit and press also the Secondary Power
Button – l.).
Boot time of the KVM Combiner is about
40-60 seconds
By default, after product power-up, the
active channel will be computer #1,
indicated by the applicable front panel
f
g
e
f
g
e
m
AFP remote control WR80-3
SC82PH-4 SC162PH-4
push button LED lit.
NOTE : HSL devices covered by this manual
include a special DP/HDMI connector, enabling
the user to use the product with both video
formats as input and output.
EDID Acquisition
The HSL KVM combiner has a fixed EDID file
which is transmitted to all connected PCs. At
no point will the actual connected display EDID
be transferred to the connected PCs.
h
i
h
l
Notes
•
Power ON Self-Test Procedure: As the product powers-up it
performs a self-test procedure. In case of self- test failure for any
reason, including jammed buttons, the product will be Inoperable
and self-test failure will be indicated by abnormal LED behavior. In
this case, please call
Technical Support and avoid using the
product.
For further information please refer to the product
administrator and setup guides.
| QUICK INSTALLATION GUIDE
Index:
a.
Primary HDMI Output
b.
Secondary HDMI Output
c.
DP/HDMI Inputs
d.
USB-B PC Inputs
e.
Console Keyboard/Mouse
USB
f.
Console HID LEDs
(Keyboard/Mouse)
g.
RDC input (for AFP)
h.
Primary DC In
i.
Secondary DC In
j.
Primary Power LED
k.
Primary Power Button
l.
Secondary Power Button
m.
Secondary Power LED
HDC19963 Rev.1.0
Advertisement
