SECOLink KM20B Short Programming Manual - Basic Information page 10

Intruder alarm system
PROJECT LOADING
Service Mode }Project Loading
If entered the keypad initiates a communications session with the PC. Software MASCAD is used to program
Project Loading:
| } SECOLINK intruder alarm system. Note: it is necessary to register modules to the system, if a new module was
Open USB Port
added to the project by using MASCAD software. After module registration the data from the keypad should be
Open USB Port
sent to the system.
Ready ...
If entered the control panel will start uploading the project to all registered system modules.
Project Loading:
| }
From CP to KM2
From CP to KM20
Processing...
If entered the keypad will start uploading the project to control panel and all registered system modules.
Project Loading:
| }
From KM20 to C
From KM20 to CP
Processing...
Two sub-menus are available:
Project Loading:
| }
Restore Project
Restore Project:
| }
Main settings
Restore Project:
| }
Full project
LANGUAGE
Service Mode } Set Language
Usually the keypad is supplied with 3 languages.
Set Language:
| }
English
UNREGISTER MODULES
Service Mode } Unreg. Modules
Used to unregister system modules. The message First Start Press [ENT] will appear on keypad's LCD screen
Service Mode:
| } when this procedure will end.
Unreg. modules
Page 10
Main settings - restores all settings, excluding entered names and reporting settings.
Full project - restores all settings to factory default values.
System with KM20B keypads
Short programming manual - basic information