Related Manuals for Franke 2DCF-30
Summary of Contents for Franke 2DCF-30
- Page 1 OPERATION & INSTALLATION MANUAL 30" COMBO FREEZER COOLER MODEL: 2DCF-30 PART NUMBER: 18012935 30" Combo Freezer Cooler...
-
Page 2: Important Safety Information
- NEVER make ANY modifications to the unit that are Refrigeration systems that use R-290 (Propane) not authorized by documentation provided by Franke . present a life-threatening hazard of fire or explosion. - NEVER remove any labels from the unit. -
Page 3: Table Of Contents
IMPORTANT SAFETY INFORMATION - ONLY persons who are certified technicians or NOTICE trades persons with the requisite knowledge, skills, NEVER use inappropriate tools, processes, or ability, and training, MUST perform service or procedures. Damage to components of unit can occur. installation work. -
Page 4: Key Components
KEY COMPONENTS Overview The 2-Drawer Combo Freezer/Cooler provides tem- uct. The drawers and optional organizers can be eas- porary, point-of-use access to fresh proteins at the ily removed for cleaning. Two digital temperature con- grill station. Two drawers - an upper, freezer drawer trollers allow for monitoring and adjusting the current and a lower, refrigerated drawer - can hold specially temperature of each of the drawers. -
Page 5: Installation
INSTALLATION Installing the Freezer/Cooler 1. Remove any packaging from the outside and inside of the unit. 2. Remove any protective film covering the stainless steel surfaces and loose parts. 3. Remove drawers (Fig. 2) (refer to Drawer Removal , Page 8 ) and inspect unit to ensure fans and air return holes are clear (Fig. -
Page 6: Controls & Settings
CONTROLS & SETTINGS Power On/Off Switch FREEZER REFRIGERATOR CONTROLLER NOTICE CONTROLLER NEVER turn the Power Switch OFF when the unit is in use! Doing so may result in spoilage and loss of stored food products. Fig. 8 The 2-Drawer Combo Freezer/Cooler is provided with 1. -
Page 7: Manual Defrost
CONTROLS & SETTINGS Manual Defrost 2. The display will read “dEF” (Fig. 13). The compressor will shut off and the heater will begin NOTICE to melt excess ice buildup. The controller will display the current temperature once defrosting The 2-Drawer Combo Freezer/Cooler is equipped with is complete. -
Page 8: Daily Cleaning/Store Closing
OPERATION Daily Cleaning/Store Closing 4. Lift drawer front slightly, and pull forward to remove (Fig. 17). Set the drawers on a clean 1. Turn the power switch OFF. surface, such as a cart. 2. Unload all remaining product, and place into the appropriate cold storage to maintain holding standards. -
Page 9: Drawer Installation
OPERATION 7. Lift the front end of each drawer slider, and slide free from the rails in the interior of the refrigerated cabinet (Fig. 20). Fig. 22 3. Reopen the drawer and pull outward until it Fig. 20 stops. Push the drawer lock upward while simultaneously towards the back of drawer to Drawer Installation lock the drawer in place (Fig. -
Page 10: Troubleshooting
Set point temperature (refer to Freezer/Cooler Temperature Adjust- drawer freezes. of controller is too low. ment , Page 6). If following these steps does not fix the problem, contact Franke at (800) 537-2653 and press 2 for Technical Support. of 12... -
Page 11: Warranty
- Service by a non-authorized service company. - Use of non-OEM (Original Equipment Manufacturer) parts. This warranty is conditional upon Franke receiving notice of any defect subject to this warranty within thirty (30) days of its original discovery by the Buyer. - Page 12 © 2017 Franke Foodservice Solutions, Inc. This media is the confidential and proprietary property of Franke Foodservice Solutions, Inc. and shall not be reproduced in any form of media without the express written permission of Franke. Due to continuous product development, Franke reserves the right to make changes in design and specifications without prior notice.
Need help?
Do you have a question about the 2DCF-30 and is the answer not in the manual?
Questions and answers