Sony RM-PG411 Primary Operating Instructions Manual page 5

Note that the function buttons are factory-
set as described in the table above. If you
want to change the factory setting of the
buttons to match your particular
components, do the procedure
"Programming the remote" on page 10.
AV1, AV2, 2ND buttons
Press to select the command mode of the
remote (page 10).
M1, M2 buttons
Press to use Macro Play function (page 15).
MULTI CH button
Press to select the multi channel input
sources.
SOURCE button
Press to select 2ND AV output.
4 SOUND FIELD buttons
PRESET button
Press to select a preset sound field (ex.
CINEMA STUDIO EX A, B, C).
AUTO DEC button
Press to set the receiver to automatically
select the appropriate sound field for the
input signal.
This button can be used only with receivers
that have digital inputs.
ANALOG DIRECT button
Press to select 2CH ANALOG DIRECT.
2CH button
Press to turn the sound field off and listen to
2 channel stereo sound.
Multi channnel source is also downmixed to
a 2 channel stereo sound.
MODE +/– buttons
Press to select sound fields.
5 MUTING button
Press to mute the sound.
6 MASTER VOL +/– buttons
Press to adjust the volume level of all
speakers at the same time.
7 MAIN MENU button
Press to select the cursor mode of the
receiver (EQ, SURR, LEVEL, SET UP or
CUSTOMIZE).
8 ON SCREEN button
Press to display the menus of the receiver
on the TV screen (only when the ALT
button is not lit).
9 V/v/B/b/ENTER/EXECUTE button
After pressing the MAIN MENU, AV
MENU, or TOP MENU/GUIDE button, use
the button to make specific settings, then
press the button to enter the selection.
0 TEST TONE button
Press to output a test tone.
continued
GB
5