TESY WEF200SRELW TR Installation, Operation And Storage Manual page 5

BOOT STEPS
1. Connect the power
2. Turn on the power switch
3. Press the control switch or „ON/OFF" key of the
remote controller to start up
HEATING DEVICE
1. Press the 1000W button to can control the low-level
heating of the fireplace and stop heating
2. Press the 2000W button to can control the high-
level heating of the fireplace and stop heating.
AUTOMATIC HEATING
Press IC button on the remote controller to start or exit
the automatic heating.
When turned on, the fireplace can automatically change
the heating mode depending on the set temperature
and the room temperature.
During a timed starting process, it is possible to start
heating ahead of schedule.
MONOCHROME FLAME FIREPLACE WITH
ADJUSTABLE FLAME BRIGHTNESS
Method one: Hold down the control switch О/I (
) button, the flame brightness changes, release the
button when the desired brightness is reached.
Method two: press „DIMMER" button on the remote
controller, the flame brightness may change step by
step with each press of the button.
SETTING THE DATE AND TIME
1. Settings are done on the remote controller;
2. Press „DATE TIME" button, then press the
key to select the date;
3. Press „DATE TIME" button again, then press the „+"
or „-" to set the hour
4. Press „DATE TIME" button again, then press the „+"
English
Indicator
Button
or ,
or „-" to set the minute
5. Press „OK" button to complete
TEMPERATURE SETTING
The default set temperature is 20°C, press „+" or „-" on
the remote controller to set the temperature, which
ranges from 15 to 30°C, and this is the normally set
temperature (the timer is off )
TIMER SETTING
1. Description of setting
There are up to 10 items for timer setting
Each item of setting has its date, power-on time and
shutdown time
The max. duration of each item of setting is 23 hours 50
minutes
The set date for each item can be any day or days of a week
The date in each item of setting represents the date of
power-on time
If the shutdown time being set falls on the second
day, it is unnecessary to set the date – you just set the
shutdown time.
2. Steps to view the timer setting
Press the „TIMER SET" button
Press the „+" or „-" to check the power-on time set by the
timer item by item
For checking the shutdown time, press the „ " button.
Press the „+" or „-" to continue viewing
For deleting the current item of setting, press „C" to delete.
3. Time setup steps for timer setting
(I) Select the settings
Press the „TIME SET" button, and the serial number of
setting starts blinking
Press the „+" or „-" to change the serial number until you
get the serial number of setting that you need to set or
modify.
(II) Select date
Press „TIME SET" button once again, and the cursor on
the left side of date starts blinking
Press the or keys to move the cursor to
the corresponding date, press the „+" to add the
corresponding date, or press „-" to delete the date until
you have completed the selection of all dates.
(III) Set the start time
Continue to press the „TIME SET" button, the hour starts
blinking
Press the „+" or „-" to adjust the hour
Continue to press the „TIME SET" button, the minute
starts blinking
Press the „+" or „-" to adjust minute.
(IV) Set the shutdown time
Usage and Storage Instructions
EN
5