Table of Contents
Advertisement
Available languages
Available languages
appliance is covered or improperly positioned this
may cause fire.
•
Position the power cord in such a way that it does
not obstruct the free movement of people and
cannot be stepped on! Use only approved extension
cords which are suitable for this appliance, i.e. have
got a conformity sign!
•
Do not bend the power cord and do not stretch it
over sharp edges, do not position it over hot plates
or open flames!
•
Never use the electric fireplace in close proximity to
a bathroom, a shower cabin or a swimming pool!
•
Do not lift the fireplace by the front glass.
PACKING
•
After unpacking the appliance, check if all its
elements are included in the packing and that it has
not been damaged during transportation! In case
damage or incomplete delivery is found, contact
your authorized retailer!
•
Do not throw away the original packing! It could
be used for storage and transportation purposes in
order to avoid damages during transportation!
•
Disposal of packing materials should be done in
the appropriate way! Children should be prevented
from playing with polyethylene bags!
INSTALLATION INSTRUCTIONS
Note: The electric fireplace is intended only for
wall-mounted operation!
•
The fixed elements in the packing are of small size
and they should be kept away from small children.
We recommend all elements to be put in a small
box and to be stored away from children.
•
Small children should be prevented from playing
with polyethylene bags – there is risk from
suffocation. We recommend disposing of them right
after emptying them.
•
Do not connect the electric fireplace until it has
been well-mounted to the wall and you have read
all important instructions above.
•
The minimum distances in front of, above and under
the fireplace shall be observed as indicated above
and shown below.
•
During mounting you should be careful about
not damaging the cables in the walls. Please pay
attention when drilling holes in the walls. Danger
from electric shock!
•
The appliance is designed to be permanently wall-
mounted at height of minimum 300 mm from the floor.
The bearing clamp shall be in horizontal position. The
power cord is in the bottom right corner of the fireplace.
English
•
A height of 600 mm from the floor is recommended
for optimal visualization of the flame effect (see Fig.
1 for recommended dimension for mounting).
•
For optimal visualization, mark the positions of the
top 5 screws for wall-mounting in accordance with
the recommended dimension for mounting (see Fig.
2. Openings with 6 mm drill bits).
•
Mount the bearing clamp to the wall by the screws.
•
Carefully lift the fireplace upwards so that the upper
rear edge of the fireplace to lie over the bearing
plate fixed on the wall (see Fig. 2.) and position it
centrally.
•
Carefully press the fireplace to the wall.
•
Mark the position of the bottom openings (see
Fig. 3), remove the fireplace, ensuring that the
lower mounting plate is turned and will not be an
obstacle.
Usage and Storage Instructions
EN
3
Advertisement
Table of Contents
