Advertisement
● FEB will be cancelled after three photos are taken.
● For best results, set the camera drive mode to "single" and
ensure the flash is ready before shooting.
● FEB can be used with FEC and FEL.
C.Fn
You can prevent the FEB from being cancelled
automatically after three photos are taken. (C.Fn-FEB
ACL , Page 55)
FEL: Flash Exposure Lock
FEL can lock the correct flash exposure setting for any part of the
scene.
With <ETTL> displayed on the LCD panel, press the camera's
<FEL> button. If the camera does not have the <FEL> button, press
the < * > button.
●"FEL" will display on the viewfinder for 0.5s.
●The camera flash will fire a preflash and lock the flash exposure
setting once the <FEL> button is pressed.
- 33 -
1
Press function button 3
<
>. The icon <
>
and the exposure bracketing
amount will be highlighted
on the LCD panel.
2
Set the flash exposure
compensation amount.
● Turn the Select Dial to set
the amount.
● "0.3"means 1/3 step,
"0.7"means 2/3 step.
3
Press Set Button again to
confirm the setting. Then
your FEC and FEB settings
are displayed on the LCD
panel.
1
Focus the subject.
2
Press the <FEL> button.
● Aim the subject at the
center of the viewfinder and
press
<FEL>
button.
● The camera flash will fire
a preflash and the required
flash output for the subject
is retained in memory.
● If the subject is too far away and underexposure, the < >
icon will blink in the viewfinder. Move closer to the subject
and try the FE lock again.
● If <ETTL> is not displayed on the LCD panel, FE lock
cannot be set.
● If the subject is too small, FE lock might not be very
effective.
High-Speed Sync
High Speed Sync (FP flash) enables the flash to synchronize with
all camera shutter speeds. This is convenient when you want to use
aperture priority for fill-flash portraits.
● If you set a shutter speed that is the same as or slower
than the camera's maximum flash sync speed, <
will not be displayed in the viewfinder.
● With high-speed sync, the faster the shutter speed, the
shorter the effective flash range.
● To return to normal flash, press <
Then <
> will disappear.
● Multi flash mode cannot be set in high-speed sync
mode.
● Over-temperature protection may be activated after 15
consecutive high-speed sync flashes.
Second-Curtain Sync
With a slow shutter speed, you can create a light train following
the subject. The flash fires right before the shutter closes.
- 34 -
1
Press Function Button 2
<
> so that <
> is
displayed.
2
Check that <
> is displayed
in theviewfinder.
>
> button again.
Press function button 2 <
button so that <
> is displayed
on the LCD panel.
>
Advertisement
