Advertisement
7. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash.
You can shoot with a different flash output setting for each
Receiver unit (firing group). Set all parameters on the Transmitter
unit.
Setting <M> Flash Mode
You can directly operate the Receiver unit to manually set the
manual flash or stroboscopic flash.
8. Multi: Wireless Flash Shooting with Manual Flash
CH 21
CH
1
Setting the flash mode to
<M>.
2
Setting flash output.
●Press FunctionButton
1/2/3/4<A/B/C/D>. Turn the
Select Dial to set the flash
output of the groups. Press
Set Button to confirm.
3
Taking the picture.
● Each group fires at the
set flash ratio.
1
Setting the Receiver unit.
2
Setting flash mode to <M>.
●Press
<MODE>
button so
that
<M>
is displayed.
●Set the manual flash
output. (Page 44)
1.Setting <MULTI> stroboscopic
flash.
● Press <MODE> button so that
<MULTI> is displayed.
● Setting the stroboscopic flash.
(Page 45)
- 43 -
The Reason & Solution of Not Triggering in Godox 2.4G
Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless
base station, 2.4G wifi router, Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+
channels) and use the channel which is not disturbed. Or turn off
the other 2.4G equipment in working.
2. Please make sure that whether the flash has finished its recycle
or caught up with the continuous shooting speed or not(the flash
ready indicator is lighten) and the flash is not under the state of
over-heat protection or other abnormal situation.
→ Please downgrade the flash power output. If the flash is in TTL
mode, please try to change it to M mode(a preflash is needed in TTL
mode).
3. Whether the distance between the flash trigger and the flash is
too close or not0.5m
→ Please turn on the "close distance wireless mode" on the flash
trigger
X2 & X1 series: press the test button and hold on, then turning
it on until the flash ready indicator blinks for 2 times.
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in
the low battery states or not
→Please replace the battery(the flash trigger is recommended to
use 1.5V disposable alkaline battery).
Sync Triggering
7KH 6\QF &RUG -DFN LV D
PP SOXJ ,QVHUW D WULJJHU SOXJ KHUH
and the flash will be fired synchronously with the camera shutter.
Auto Focus Assist Beam
In poorly-lit or low-contrast shooting environments, the built-in
auto focus assist beam will automatically light on to make it easier
for autofocus. The beam will light up only when autofocus is
difficult and get out as soon as the autofocus becomes correct.
If you want to turn off the auto focus assist beam, set the "AF" to
"OFF" on the C.Fn settings.
● If you find the auto focus assist beam does not light up,
this is because the camera has got a correct autofocus.
Position
Effective Range
Center
0.6~10m / 2.0~32.8 feet
Periphery
0.6~5m / 2.0~16.4 feet
Bounce Flash
By pointing the flash head toward a wall or ceiling, the flash will
bounce off the surface before illuminating the subject. This can
soften shadows behind the subject for a more natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a
satisfying angle.
- 44 -
Advertisement
