Operating The Device Safely; Control Panel - TESY DHF20CEL User And Storage Instructions

INSTALLATION
LOCATION
1.Place the unit on a firm, level surface in an area with
at least 30cm of free space around it to allow for proper
air circulation.
2.Never install the unit where it could be subject to:
• Heat sources such as radiators, heat registers, stoves
or other products that products that produce heat.
• Direct sunlight
• Mechanical vibration or shock
• Excessive dust
• Lack of ventilation, such as cabinet or bookcase
• Uneven surface
English
Top panel
Handle
Air Filter
Back Shell
Continuous
drainage
Water tank

OPERATING THE DEVICE SAFELY

• Check the device after unpacking for any damages
or scratches on it.
• Operate this unit in an ambient temperature from
5°C to 35°C.
• Do not use in the outdoors. This dehumidifier is
intended for indoor residential applications only.
• Do not operate in close proximity to walls, curtains,
or other objects that may block inlet and outlet.
• Keep the air inlet and outlet free of obstacles.
• Adjusting the wind deflector in the upward
direction prior to start up.
• If tipped more than 45°, allow the unit to set upright
for at least 24 hours before start up.
• Keep doors and windows close for better energy
saving.
• Do not operate or store the unit in direct sunlight
or rain.
• It is normal for air outlet to feel warm to touch after
continuous operation on hot days.
• Empty the water tank before moving the device.
• Make sure the Water tank is correctly fitted
otherwise the unit will not operate properly.
• The dehumidifier starts up in the mode selected
when the unit was last used.
• The dehumidifier starts dehumidifying if the room
humidity is 3% higher than the selected humidity.
• There is a protective 3-minutes time delay of the
compressor. Wait 3 minutes for the dehumidifier to
resume dehumidification.
OPERATION
DIGITAL DISPLAY
Blue
Humidity <45% 45%≤ Humidity ≤65%

CONTROL PANEL

Green Red
Humidity >65%
Usage and Storage Instructions
EN
3