Launch M-Diag Lite User Manual

Download this manual

Original Launch M-Diag Lite for IOS Android User Guide

Launch M-Diag Lite official site:

Introduction:

Launch M-Diag Lite Working Status:

Constant green light

Flickering red light

Download and install the M-Diag App

1.M-Diag App available on the Apple App Store and Google Play Store.

2. Scan the QR Code to download the App

Note:

Due to the system restraints of Apple iOS, a new App will be required to install on the first

time to open the diagnostic software. Please use the M-Diag App to perform vehicle

diagnosis.

FCC Caution:

This device complies with part15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B

www.goloiov.com

Working norma1ly

Bluetooth connecting

Page 1 Original Launch M-Diag Lite for IOS Android User Guide Launch M-Diag Lite official site: www.goloiov.com Introduction: Launch M-Diag Lite Working Status: Constant green light Working norma1ly Flickering red light Bluetooth connecting Download and install the M-Diag App 1.M-Diag App available on the Apple App Store and Google Play Store.
Page 2 digital device, pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Page 3 2. M-Diag device activation Enter the S/N and A/C (Activation Code) in the password envelope to active the M-Diag device.
Page 4 3. M-diag device installation Step 1: Find the OBDll port,which is usually located underneath the dashboard; Step 2:Plug the M-Diag into the OBDll port of the vehicle and the LED indicator will light up to show the operating status.
Page 5 Note: 1. Remove the M-Diag device after using. Do not leave it in the OBDllport; 2. Turn off the ignition before plugging or unplugging the M-Diag device. Purchase diagnostic software Ste 1: Tap on "Purchase more carline software" to enter the car line software list. Ste 2: Select the carline software, tap on the vehicle icons to see more carline software details.