Parts Of The Board And Factory Defaults; Setting The Board Id - Contec CNT32-4MT User Manual

Parts of the Board and Factory Defaults

Figure 2.2. shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
- Interface connector
(CN1)
Figure 2.2. Component Locations

Setting the Board ID

If you install two or more boards on one personal computer, assign a different ID value to each of the
boards to distinguish them.
The board IDs can be set from 0 - Fh to identify up to sixteen boards.
If only one board is used, the original factory setting (Board ID = 0) should be used.
Setting Procedure
To set the board ID, use the rotary switch on the board. Turn the SW1 knob to set the board ID as shown
below.
SW1
BOARD ID
8
Factory setting:
(Board ID = 0)
Figure 2.3. Board ID Settings (SW1)
CNT32-4MT(LPCI)
SW1
Board ID setting switch
BOARD ID
(SW1)
2. Setup
SW1
BOARD ID
8
15