Handling Instructions - Denzel BLG-IB-18-02 User Manual

8
General view of the tool is shown on picture 1.
2
3
1
9
1. Protective cover fastening lever
2. Spindle lock button
3. Gear housing
4. Switch key
5. Main handle
6. Rechargeable battery
7. Battery Lock Key
8. Side handle
Machine unit
The machine consists of a plastic housing with a brushless electric motor located in it and a gearbox, on which
output shaft (spindle) with the tooling is installed. On the gearbox housing there is a button 2 (pic. 1) of the spindle
lock, providing spindle lock when changing the tooling. On the body of the engine there is a key 4 (pic. 1) for the engine
start, having the ability to be fixed in the "on" position. The motor housing goes into the main handle 5 (рiс. 1),
terminating in battery connector.
The machine is equipped with a protective cover with the ability to change its position without using a tool.
The battery is equipped with a residual charge indicator 12 (рiс. 1), which is enabled using the button 11 (рiс. 1).
The indicator turns off automatically after 3 ... 4 seconds after pressing the button 11.
RECHARGEABLE ANGLE GRINDER WITH BRUSHLESS MOTOR

HANDLING INSTRUCTIONS

8
4
13
14
15
16
Рiс. 1
5
9. Tooling
10. Battery protection key
11. Battery charge indicator button
12. Battery charge indicator
13. Charger
14. Charger contacts
15. Charger Protection Key
16. Charger indicator
7
6
6
10
12
11