Noise And Vibration; Maintenance - Denzel BLG-IB-18-02 User Manual

12
At the end of the work:
•
disconnect the tool from the power supply, making sure the switch is in the "off" position;
•
clean the tool and accessories from dirt.
Recommendations for use
Before you start processing a part, you must fix it, if it has a light weight.
For maximum grinding efficience angle formed by the abrasive wheel and the surface should be between 30 - 40
degrees. Move the machine smoothly along the surface to be treated. Thus, the overheat and change of color
of the processed surface is excluded, processing quality is improved.
ATTENTION!
Never use a cutting wheel for grinding.
When cutting with a cutting wheel do not put pressure on the handles of a power, tilt it. Avoid vibration and tilting
disc. It is necessary to work carefully, taking into account the characteristics of the material being processed.
It is very important to consider the direction of movement of the power tool. Power tools must be moved against
the rotation of the disc, otherwise there is risk of losing control on the power tool.
When cutting profiles and rectangular pipes it is recommended to start cutting from the narrower end.
Do not overheat the exterior of the machine during prolonged use. If overheated, stop working, let the machine
work without load for 1 ... 2 minutes to cool the engine, turn off the engine and take a break to cool down
the gear housing.
Do not allow the machine to work when there is unwanted or unusual noise in the engine or mechanism. If noise
appears turn the machine off and contact to an authorized service.
Noise and vibration characteristics are given in the table №1.
However, if the Electrical Rotary Hammer will be used for other work with the use of working tools, not provided
by the manufacturer, or maintenance will not meet the requirements, then the vibration level may be different.
ATTENTION!
Always use personal hearing protection.
ATTENTION!
Before starting maintenance work and setting up the tool disconnect the battery. To ensure
quality and safe functioning keep your tool and vents clean at all times.
If you have noticed a decrease in the efficiency of the tool, extraneous noise or smell then you must contact
the service center for timely diagnosis and repair.
Tooling maintenance
The use of the worn working tool reduces the effectiveness of the work and may result in motor or gearbox failure,
so you need to sharpen periodically or replace worn removable tools, as soon as there is a need.
Electric motor care
You must be especially careful with the electric motor, avoid getting liquids and foreign objects inside the case.
Keep your ventilation holes clean, blow them regularly with compressed air or clean them with a brush.
RECHARGEABLE ANGLE GRINDER WITH BRUSHLESS MOTOR

NOISE AND VIBRATION

MAINTENANCE